ARB Air Locker Land Rover 24 Spline

  • Sale
  • Regular price £825.00
  • Will not ship until

The ARB Air Locker is a pneumatic locking differential that uses air to facilitate the locking of both axles. This action converts your differential from a conventional open to a full spool type axle supplying 100% power to both wheels to keep you going through the worst terrain.

A relentless commitment to research and design, the use of quality materials, and an uncompromising approach to manufacturing have all contributed to the Air Locker’s success in over 100 countries worldwide.

Designed and manufactured in Australia, ARB Air Lockers will enhance the traction of your 4×4 in just about any terrain, whether it’s rock, clay, gravel, sand, snow or mud.

Now with a state-of-the-art two piece design available right across the range, forged gears for the ultimate in strength and durability, and an industry-leading five year warranty, ARB Air Lockers are better built and better backed than ever before.

Forged Gears
Strength, durability and resistance to fatigue in all Air Locker components is paramount. With phenomenal forces being applied to the side and pinion gears within the differential, ARB has invested heavily in the application of forged gears, typically found in heavy duty commercial, race and agricultural transmissions. When combined with ARB’s patented ‘timed gear’ design, the resulting strength of the whole assembly is amplified.

Two Piece Design
Housing this superior internal gear train in a two-piece case brings further benefits. Machining a case from two pieces instead of three results in a much higher dimensional accuracy of the finished assembly and has allowed ARB engineers to improve the design of other elements, resulting in a reduction of moving parts, increased strength and a more responsive activation.

ARB onboard air compressor required to activate Air Lockers (sold separately)

Land Rover
Range Rover Classic 1993-96 front & rear (see note 1 & 2)
Discovery 1993-98 front & rear (see note 1 & 2)
Discovery 2 1998-2004 front & rear (see note 3)
Defender 90 1993 on front & rear
Defender 110 / 130 2002 on rear (not Salisbury or P38 style)
Defender 110 / 130 1993 on front

Note 1 - If vehicle was manufactured during 1993, check spline count. Must be 24 at diff end.

Note 2 - Some vehicles have crown wheel bolts which cannot be reused and must be replaced. Consult service manual or if in doubt, you need 10 x FTC5150 crown wheel bolts.

Note 3 - P38A is most commonly found in traction control equipped vehicles. Identify P38A type diff by large 205mm [8.07"] flange diameter. P38A was not used on North American delivered Discoverys - use RD138.

Spline 24
Shaft diameter 31.5 (1.24")
Ratio 3.54

Previously RD56